Remote Triggering of cameras requires a compatible camera*, a remote IR Transmitter and SetMyCamPro. The IR Transmitter is a specially configured device connecting to iOS devices through the stereo output port. These can be purchased as ready to use adapters or they can be assembled from easily obtained components with directions on the DIY Page.
SetMyCamera offers pre-assembled and tested IR Transmitters. A sample IR transmitter is show below. These enable a one way communications between the iOS device and supported cameras for remote camera triggering. The IR transmitter plugs into the stereo output connector and requires SetMyCamPro for remote trigger activation.
IR Transmitter $19.95
*Use of the IR Transmitter requires SetMyCamPro and a camera model supporting the IR protocol as listed below.
Canon cameras supporting the IR protocol:
ELPH 370Z, Jr., Sport, Z3, ELAN 7/7E/7NE, Elan II/IIE
Sure Shot 130u, 130u II, Z115, Z135, Z155, Z180u, Z90W
EOS Rebel XT, XTi, XSi, T1i, T2, T2i, T3i, T4i, T5i,
EOS 300D, 350D, 400D, 450D, 500D, 550D, 1000D
EOS 6D, 7D, 60D, 60Da, 100D, 600D, 5D Mark I, II, III, 6D, 7D
Nikon cameras supporting the IR Protocol:
Nikon 1: J1 & V1, D40 / D40x, D50, D50, D60, D70, D70s D80, D90,
Nikon D3000, D3200, D5000, D5100, D7000,
CoolPix P7000, P7100, 8400, 8800
Nikon F55, F65, N65, N75, Pronea S, Nuvis S,
Lite•Touch 150ED QD, 140ED QD, 130ED QD, 110s QD, 100W QD
Please consult camera owners manual for use of IR remote triggering, MLU, Bracketing and bulb mode settings. Use of the IR protocol is a one way communications and cameras are not remotely configurable by SetMyCamPro. It is the photographers responsibility to properly configure the camera by methods outlined in the camera’s user manual.