IR Transmitter
Remote Triggering of cameras requires a compatible camera*, a remote IR Transmitter and SetMyCamPro. The IR Transmitter is a specially configured device connecting to iOS devices through the stereo output port. These can be purchased as ready to use adapters or they can be assembled from easily obtained components with directions on the
DIY Page.

SetMyCamera offers pre-assembled and tested IR Transmitters. A sample IR transmitter is show below. These enable a one way communications between the iOS device and supported cameras for remote camera triggering. The IR transmitter plugs into the headphone connector and requires SetMyCamPro for remote trigger activation.

IR Transmitter Temporarily unavailable due to postal service regulation changes


*Use of the IR Transmitter requires SetMyCamPro and a camera model supporting the IR protocol as listed below.

Canon cameras supporting the IR protocol:

Canon cameras supporting the IR protocol:
Canon ELPH 370Z, Jr., Sport, Z3
Canon ELAN 7/7E/7N/7NE, Elan II/IIE
Canon Sure Shot 130u, 130u II, Z115, Z135, Z155, Z180u, Z90W
Canon EOS Rebel XT, XTi, XSi,
Canon EOS Rebel SL1, T1i, T2, T2i, T3i, T4i, T5i, T6i, T6s, T7i
Canon EOS 5D, EOS 5D Mark II, 5D Mark III, 5D Mark IV,
Canon EOS 5DS, 5DS R,
Canon EOS 6D, 6D Mark II,
Canon EOS 7D, 7D Mark II,
Canon EOS 60D, 60Da, 70D, 77D, 80D,
Canon EOS 100D, 300D, 350D, 400D, 450D, 500D, 550D, 600D, 700D, 750D
Canon EOS M, M2, M3, M5, M6

Nikon cameras supporting the IR Protocol:

Nikon 1: J1, J2, J3, V1, V2, V3
Nikon D40, D40x, D50, D60, D70, D70s D80, D90, D600, D610, D750,
Nikon D3000, D3100, D3200, D3300, D3400,
Nikon D5000, D5100, D5200, D5300, D5500,
Nikon D7000, D7100, D7200, D7500
Nikon CoolPix A,
Nikon CoolPix P900,
Nikon CoolPix P7000, P7100, P7800,
Nikon 7700, 8400, 8800
Nikon F65, F55, N65, N75, Pronea S, Nuvis S,
Nikon Lite•Touch 150ED QD, 140ED QD, 130ED QD, 110s QD, 100W QD

Consult camera owners manual for use of IR remote triggering, MLU, bracketing and bulb mode settings. Use of the IR protocol is a one way communication limited to triggering of a supported camera.
SetMyCamPro and the IR Protocol are not able to remotely configure a camera. It is the photographers responsibility to properly configure the camera by methods outlined in the camera’s user manual.